Chiligreen P5VDC-MX Uživatelský manuál stáhnout pdf (Strana 39)

ASUS P5VDC-MXASUS P5VDC-MX

ASUS P5VDC-MX

1-271-27

1-27

2.2.

Primary/Secondary IDE connector (40-1 pin PRI_IDE,Primary/Secondary IDE connector (40-1 pin PRI_IDE,

Primary/Secondary IDE connector (40-1 pin PRI_IDE,

SEC_IDE)SEC_IDE)

SEC_IDE)

These connectors are for Ultra DMA 133/100/66 signal cables. The

Ultra DMA 133/100/66 signal cable has three connectors: a blue

connector for the primary IDE connector on the motherboard, a black

connector for an Ultra DMA 100/66 IDE slave device (optical drive/

hard disk drive), and a gray connector for an Ultra DMA 100/66 IDE

master device (hard disk drive). If you install two hard disk drives, you

must configure the second drive as a slave device by setting its

jumper accordingly. Refer to the hard disk documentation for the

jumper settings.

P5VDC-MX

P5VDC-MX IDE connectors

NOTE: Orient the red markings

(usually zigzag) on the IDE

ribbon cable to PIN 1.

PIN 1

PRI_IDE

SEC_IDE

PIN 1

1. Follow the hard disk drive documentation when setting the device in

master or slave mode.

2. Pin 20 on each IDE connector is removed to match the covered hole

on the UltraATA cable connector. This prevents incorrect orientation

when you connect the cables.

3. The hole near the blue connector on the UltraATA cable is

intentional.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 93 94

Žádné komentáře

Chiligreen P5VDC-MX Uživatelský manuál Strana 39