Chiligreen M400A Uživatelský manuál stáhnout pdf (Strana 97)

Upgrading The Computer

Upgrading the Hard Disk Drive 6 - 7

Changing Serial and Parallel Hard Disk Cables

The system can support either serial (SATA) OR parallel (PATA) hard disks,

however different cables are used to support each hard disk type. If you are

changing hard disk types then you will be required to change the cable.

1. Remove the hard disk assembly (see page 6 - 4).

2. Remove screws

& .

3. Carefully remove the cable .

4. Remove any cable protector from the new cable.

5. Insert the new cable (be careful of the connector orientation) and re-insert

screws

& .

6. Insert the new hard disk (ensure it is attached to the bracket) and make sure

it is firmly connected.



HDD Cable

You will need to bend

the cable back and en-

sure that the connector

is facing the correct di-

rection in order to con-

nect to the hard disk.

Be careful when push-

ing the cable down into

the mainboard connec-

tor. Make certain that

the cable and connec-

tor are correctly

aligned in order to

avoid damaging the

mainboard.

1 2

Figure 6 - 5

HDD Cable

Removal

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 161 162

Žádné komentáře

Chiligreen M400A Uživatelský manuál Strana 97